Photoemission experiments are at present witnessing a continuous progress towards the increase in resolution and optimization. In such experiments, the modern ability to control with the highest degree of precision the state of the incident photons in terms of momentum, monochromaticity and polarization, can be combined with state-of-the art techniques to evaluate the energy, momentum and spin state of the photoemitted electron. This allows to completely characterize the initial and final states of the probe particles and hence to reconstruct with highest precision the electronic structure of the sample under investigation and its possible excitations. Synchrotron radiation sources have been extensively employed for such purposes, as the extreme stability and tunability of synchrotron light allows to probe a broad range of phenomena directly accessible by photoemission experiments.
Another field of exploration, however, has been opened by the realization of Free Electron Lasers (FELs), new light sources able to deliver X-ray pulses of femtosecond duration and extremely high brilliance. FELs have pioneered the study a whole new plethora of behaviours: thanks to the short duration of the X-ray pulses, if a strong enough excitation driving the system out of equilibrium can be delivered, it is possible to follow with stroboscopic measurements (pump-probe method) the relaxation processes of the material in study.
However, the flux of photons in such ultrashort pulses is so large that the emitted electrons interact with each other while travelling from the sample to the detector. This space-charge effect destroys the information carried by the photoelectrons, depriving of success any attempts of performing high-resolution photoemission spectroscopy experiments. Moreover, the repetition rate of up-to-date FEL sources typically spans from hundreds of hertz to tens of kilohertz: this in turn means that performing the statistically challenging spin-resolved photoelectron spectroscopy and ARPES would be a heroic task, since the space-charge and its related disruption of any meaningful spectroscopic information requires a decrease in the energy per pulse.
An alternative route has been found in the exploitation of the High Harmonics Generation (HHG) process. Since the 80s it was known that focusing a laser pulse on a dense gas jet leads to the emission of odd harmonics of the wavelength of the incoming radiation, up to the EUV range. While this process cannot hope to reach the extreme brilliance of FEL sources, it is nonetheless able to deliver with ease pulses of 103 – 104 monochromatic photons per pulse, leading to a space-charge-free measurement condition; furthermore, repetition rates up to 1 MHz as well as pulse duration of few hundreds of femtoseconds dramatically increase count rates.
This yields a high interest especially in condensed matter physics, where the degree of correlation of the constituent particles and emergent quasiparticles allows for extremely fast relaxation times: the optimization of such mechanisms can drive towards the realization of novel functional devices in which every characteristic of the system is exploited to the fullest.
With the SPRINT project (Spin Polarized Research Instrument in the Nanoscale and Time Laboratory), we have developed a new endstation, addressed at the study of ultrafast magnetic processes in solid state physics by means of an upgraded vectorial Mott detector and a hemispherical electron analyser, suited to perform narrowband time-resolved valence band photoemission spectroscopy and spin detection.
The new SPRINT (Spin Polarized Research Instrument in the Nanoscale and Time Laboratory) has been equipped with two laser sources (PHAROS) with a common oscillator, both emitting pulses at 1030 nm, with time duration of 300 fs, variable repetition rate from 50 kHz up to 1 MHz, pulse energy of 400 J and average power up to 20 W. These lasers are at the heart of the new HHG-based beamline.
As in fig. 2, after exiting the laser the laser beam at 1030 nm is splitted by means of a coated fused-silica glass, in order to allow a proper pump-probe setup with two spatially and temporally overlapped beams to be implemented. The power ratio for our optical system is 90% reflected and 10% transmitted. In a pump-probe mindset, each of the two beams can be used for either pumping or probing, depending on what the experiment requires. As an example, the two beam profiles at 1030 nm and 515 nm are reported in fig. 3.
One of the beams is sent on a beta barium borate (BBO) crystal of about 2 mm thickness, which produces the 2nd harmonic at 515 nm with 50% efficiency; two dichroic mirrors serve the purpose of removing the fundamental while keeping the 2nd harmonic in the optical circuit. After a series of mirrors, the beam enters the generation chamber, where one 10 cm focal length lens produces a 40 mm Gaussian beam waist, that leads to a peak intensity of 1014 GW/cm2 at 1 GW/pulse.
In the generation chamber the generation gas is inserted by means of a short and narrow (70 mm internal diameter) capillary nozzle. The whole interaction region is pumped via an in-vacuum high diameter tube feedthrough, and the chamber itself is pumped by a magnetically levitated pump and a primary scroll. The pumping system has been designed to allow operation even in high backing pressure of the nozzle (up to 10 bars) and to reduce as much as possible the pressure near the laser focus to avoid X-ray absorption.
The beam emitted by the gas is composed of a superposition of the odd harmonics of the fundamental frequency of the laser. The water-refrigerated pinhole connecting the generation and the monochromator chambers blocks the 515 nm fundamental radiation from propagating further, as well as functioning as a vacuum impedance. The single-grating monochromators mounted in the off-plane geometry serve the purpose of selecting one specific harmonic and conserving the time duration of the pulse. The harmonics are dispersed in the direction perpendicular to the beam propagation plane; by rotating the grating along the optical axis of the system, the desired spectral range is reflected on a second toroidal mirror, which focuses horizontally the radiation.
The selected harmonic may be measured in intensity in a dedicated chamber, where a channeltron can be inserted in the beam path and the photocurrent measured. If the channeltron is removed, the harmonic can propagate until meeting a refocusing mirror that compensates the horizontal divergence due to focussing on the slits. The beam then grazes the edge of the beam alignment mirror and propagates onto the sample in the endstation.
Other than seeding the HHG process, the lasers may power three Optical Parametric Amplifiers (OPAs). These systems generate the second harmonic of the fundamental with high efficiency, produce white light in a non-linear crystal and amplify a selectable wavelength of white light: the process results in an almost continuous (5 nm steps) tunable wavelength conversion with more than 10% efficiency. The two light conversion ORPHEUS F and ORPHEUS ONE HP cover respectively the 210-2500 nm and 1350-16000 nm ranges with pulse lengths of 200 fs, while the newly installed ORPHEUS HP covers the 630-2500 nm range with a pulse length of 50 fs. The beams are then sent in a delay line, which allows a fine tuning of the temporal distance between pump and probe pulses: this means that the signal of the photoelectrons in the detectors can be related to a specific instant in time.
The main instrument is a Mott detector measuring the spin-polarization of the electrons photoemitted under the photon pulse excitation.
When using the HHG source, the spin-polarization signal comes mostly from the secondary electrons, which undergo several inelastic collisions when travelling in the material. For this reason, a high spin-polarization is observed in the extremely low energy component of the photoelectron spectrum; this value is proportional to the magnetization state of the sample. Such information is retrieved only from the extreme surface, as experiments of overlayer deposition proved that the magnetization signal is lost after deposition of few Å of non-magnetic material.
Conversely, the low-energy photons provided by the OPAs allow to emit electrons from the near-Fermi region with minimal kinetic energy: this threshold photoemission regime is characterized by no average magnetization signal, but gives access to the magnetic moment of the electrons in the bands. The low kinetic energy of the photoelectron means also that the probing depth exceeds several layers of material, making it a more bulk-sensitive technique.
The spin-polarization of the photoemitted electrons is measured through the classical Mott scattering asymmetry: electrons accelerated to 40keV hit a gold target and are then detected by two detectors at ±120° in the scattering plane. Spin-orbit interaction with gold nuclei results in an asymmetry dependent on the polarization of the incoming beam. Such asymmetry is then proportional to the polarization of the incoming electron beam along the direction perpendicular to the scattering plane:
A vectorial Mott detector features two orthogonal scattering chambers in which eight detectors are mounted, featuring a total of four scattering planes: three are orthogonal and one is redundant and used to cross calibrate the signals. An electrostatic switch allows to change in no time from one target to the other, realizing a quasi-simultaneous measurement of the three independent components of the spin-polarization.
The instrument has been mounted in a dedicated UHV chamber, where a suitable sample environment has been designed to meet the demanding criteria of such kind of measurements. The complex signal readout was upgraded with high-performance electronics able to operate both in the pulsed, high peak flux regime (for pump-probe experiment with ultrashort pulses) and in the continuous steady flux mode (the standard mode for synchrotron or laboratory sources).
On top of the spin-polarization analysis, the endstation is equipped with a hemispherical electron analyser (SCIENTA 2002, r = 200 mm) with less than 1 x Ep resolution. The SCIENTA analyser is the main tool for the investigation of the energy resolution of the HHG pulse, which has been measured by means of the acquisition of the Fermi edge of polycrystalline Au at low temperature. Fig. 7 shows the spectra acquired with the 7th and the 9th harmonic and their correspondent overall energy resolution. The energy bandwidth of 22 ± 2 eV combined with the measured temporal resolution of 105 ± 45 fs means that the radiation is near the transform limit, which in turn allows to measure superb quality valence band photoemission spectra.
|UHV base pressure||2 × 10 -10 mbar|
|Residual magnetic field||Below 2 × 10 -7 T|
|On sample magnetic field||± 1000 A/m|
|On sample maximum voltage||± 2 kV|
|Cryogenic cooling||300 K (room temperature) to 40 K|
|Annealing stages||300 K to 800 K on manipulator, 300 K to 1300K on high temperature stage|
The research activity of Dr. Panaccione is mostly devoted to the exploitation of Synchrotron Radiation spectroscopies for the study of correlated systems and novel quantum materials, following three main axes: (1) electronic and magnetic properties of low dimensional sys- tems (surfaces and interfaces), (2) electron confinement, and (3) complex oxides.
My research activity is focused on non-linear spectroscopy on condensed matter and realization of a new high harmonic generation beamline for photoemission spectroscopy at high repetition rate. My work was focalized on time resolved (“pump and probe”) spectroscopy based on table top and free electron lasers.
The common feature of my research activity has been the study of thin film growth by means of various electronic spectroscopies; in particular, in the past I have worked on metal-organic interfaces, while now I am focusing on the electronic and magnetic properties of highly correlated materials like manganites and titanium dioxide. To this aim I am currently working at the commissioning of a new apparatus which will allow to perform spin and time resolved photoemission exploiting a High-Harmonic-Generation source.
I am currently working at SPRINT-NFFA laboratory, completing my master thesis. My activity is mostly devoted to the implementation and optimization of the XUV source from High Harmonics Generation in gas phase, starting from a mode-locked pulsed IR laser, used for time-resolved photoemission experiments.
I am focusing my research on the study of phase transitions in magnetic materials, by leading the system into an out of equilibrium state via optical excitation and following the deexcitation process to the ground state with time-resolved probes.